User Tools

Site Tools


speeds_and_feeds_guide

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
speeds_and_feeds_guide [2017/04/08 16:30]
admin [Calculating Feed:]
speeds_and_feeds_guide [2017/04/08 16:32] (current)
admin [Calculating Depth of Cut]
Line 36: Line 36:
  
 ====== Calculating Depth of Cut ====== ====== Calculating Depth of Cut ======
-The rule of thumb is to cut no deeper than 1/2 of the diameter of the cutter.+The rule of thumb is to cut no deeper than 1/2 of the diameter of the cutter ​if you're cutting a pocket using 100% of the tool.
speeds_and_feeds_guide.txt ยท Last modified: 2017/04/08 16:32 by admin